AMI NiteHAWK Información técnica descargar pdf (Pagina 78)

Section 3 – Operator Screens

72 21822706

8.5 Credit Device Tests

The Credit Device Tests screen will allow testing

of credit devices without causing the corresponding

amounts to be recorded by the jukebox. During

these tests, credit will not be given for the amounts

deposited. After testing has concluded, be sure to

remove any coins and bills you may have used for

the test.

As coins, bills, and credit cards are inserted, an ID, Value, and Time will be displayed on the screen. Use this information to

verify that each device is working properly.

Note: Full credit card numbers will not be displayed, only the last five digits will be shown.

Touch the Clear Results button to clear all values displayed on the screen.

Note: Due to hardware limitations the following behavior will be noticed for each device as follows:

Coins:

- Enabled, coin parameters will be displayed as each coin is deposited

- Disabled, coin parameters will not be displayed however coins will still pass through to the coin box.

Bills:

- Enabled, bill parameters will be displayed as each bill is validated and accepted

- Disabled, if the jukebox has a 6 wire bill acceptor harness installed the bill acceptor will actually be disabled. If a

3 wire bill acceptor harness is installed, bill parameters will not be displayed but the bill will not be disabled and

bills will continue to be accepted by the bill acceptor.

Cards:

- Enabled, card parameters will be displayed as each card is swiped through the reader

- Disabled, the card reader is not physically disabled however card parameters will not be displayed on the screen

for each card swipe.

To return to the Service Mode – Main Menu, touch the Back button.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 86 87

Sin comentarios

AMI NiteHAWK Información técnica Pagina 78